At a rate of about one rosette every two months, I’ve finally finished my second!
With saturated red-oranges, prints resembling snowflakes (at least if you squint), and wintery novelty prints (polar bears and Heather Ross/munki munki ice skaters), I call this my “fire and ice” rosette. I mentioned in earlier posts (here and here) that I plan to make my entire quilt in blues and oranges.
I know I also said this before, but the rosettes are HUGE! I took a photo with my feet for perspective.
Here’s a progress shot to show how I work. I got the hour basket as a swap gift for my birthday (#birthdayclubhandmade) and keep pretty much everything I need inside it so I can take it with me to the coffee shop on weekends.
Probably my rosettes would go a lot faster if I worked only on one at a time from start to finish. Instead, I usually finish the center of one, start basting (hand sewing), get bored, and sew another center or two in the meantime. I am currently started on three other rosettes.
One of my new rosettes will feature a single image in the center. Some quilters have done an incredible job of lining up individual pieces. I plan to shortcut the process and combine a few pieces at once. Here’s the process I’m using:
First, I made a template of the rosette center. I think this is no major feat since anyone can line up a few diamond shapes, and it’s pretty obvious how they fit together if you’ve seen a photo of even a single rosette. The trick to La Passacaglia is how all the rosettes fit together. Definitely get the book if you want to make the quilt!
After printing a template, I cut out the center of one of the images.
I lined up my fabric underneath the cut template.
Then I cut around the outer edge of the template to add 3/8″ seam allowance. Since the lines are traced by hand around the paper pieces, I used an acrylic ruler with my rotary cutter (for the outer edge) and Xacto knife (for the center piece). When you’re done cutting, you should have two pieces (one fabric, one template) like this:
You could start basting your fabric to the center template at this point, but I wanted to glue mine in place for precision.
Place your fabric wrong side up. Line up the seam allowance piece around the outer edges of your fabric.
Place the center piece (with diamonds meeting in the middle) wrong side up. Glue the back of the center piece using either a fabric glue pen or a washable glue stick. Glue the center piece to the fabric (obviously glue side down), lining it up with the seam allowance piece. Then remove the seam allowance template and press.
Note on laser printers: Since laser printers use heat to bond ink to paper, running your iron over laser ink is like getting paper wet when it’s been written on with washable marker: the ink will smear. If you’re using a laser printer, I suggest placing a piece of scrap fabric over the template before pressing. Also, it’s best to press without steam since the humidity from steam will curl your paper.
Here’s the final piece held up to the light so you can see the seam allowance through the fabric:
One final note: I traced around each piece separately when making my template so I could use it as a single piece or remove any portion (e.g. removing one diamond to use a different fabric). However, it is much easier to baste convex corners (corners pointing outward) than concave corners (corners pointing inward), so keep that in mind if you remove a portion of the center template.
Check out my WIPs page for links to all my La Passacaglia posts.